Let’s take a look at how to install the mixing cylinder of the 9029 machine Let’s install the solvent pump first, Get it on first: The screws should be loosened a little, not so tight: Then we’ll tighten it up: Then we put this fixed block down，be careful when placing Pay attention to the lower wires when installing Then install it like this: You can install the holders These fixed bars are so installed: Then we put the mixing cylinder on, this must be stuck in place, otherwise, it will leak ink: Let’s put the lid on This O-ring must be put on: Get a little wet: Let’s put the lid on: With screws installed, the mixing cylinder is basically installed： Be sure to tighten the screws. Now put these two tubes on: Then install the solenoid valve: We installed the drive plate: Put the lines in order, 12345: And then we plug the lines in now: If these lines we want to tear down, we must remember, they are all in order, 12345 The jack above doesn’t have to be plugged in Then one of the ones here was supposed to be connected to the cleaning pump: Then this wire is connected to the condenser: Be sure to remember. Secure the pressure sensor, with a strap, be sure to secure it tightly: After this is fixed, then we plug in the line of the pressure sensor Just this hole, plugin here: The mixing cylinder is already in place. Special attention